Congratulations to vtecmec for winning May/June's Lude Of The Month, with his DIY Turbo BB1 build.
>>> Click Here For Profile <<<
>>> Click Here For Profile <<<
Chassis- - 4G ABS Fault Codes
- Ammo
- Admin | Spammer Assassin
- Posts: 2945
- Joined: Sun Jun 20, 2010 10:35 pm
- My Generation: 4G
- Location: Boston
- Been thanked: 6 times
- Contact:
Chassis- - 4G ABS Fault Codes
Reset ABS Fault Codes
The procedure to reset the ABS codes is as follows:
- Plug in a paper-clip to the blue service connector under the dash.
- Press the brake pedal and hold.
- Turn the ignition key to the second position (not starting the car).
- When the ABS light goes out take your foot off the brake.
- The light will come back on, press the brake pedal again and hold.
- After the light goes out, release the pedal.
- The light will blink twice to indicate the DTC code was erased.
- GreenyUK
- Supporter 2014
- Posts: 994
- Joined: Fri Dec 06, 2013 7:28 pm
- My Generation: 4G
- Location: Bristol
Hi, I've just tried this but it didn't work? Tried it 3 times.
With the pedal pressed when the ignition is turned on the abs light flashes it's code, when it stopped and wasn't on I let go of the pedal it then flashed the code again. It did not go out or flash twice? Just keeps showing me damn code.
Really wound me up lol
With the pedal pressed when the ignition is turned on the abs light flashes it's code, when it stopped and wasn't on I let go of the pedal it then flashed the code again. It did not go out or flash twice? Just keeps showing me damn code.
Really wound me up lol
- wurlycorner
- Ye are glad to be dead, RIGHT?
- Posts: 21247
- Joined: Sat May 19, 2012 3:33 pm
- My Generation: 4G
- Location: Chelmsford, Essex
- Has thanked: 2019 times
- Been thanked: 246 times