How to Reset the 4WS System

From Wiki-Lude | The UK Honda Prelude Club | Lude Generation

Jump to: navigation, search



If you wish to Reset the 4WS follow these steps..

1. Apply the hand brake.

2. Short the service connector pins with a paper clip or something similar.(Basically put the Paper clip in the connector).

3. Turn the steering wheel to CLOCKWISE (right) 45-65 degrees and hold it that way.

4. Turn the ignition switch to II (on) position but DON'T start your engine. You'll see that all your warning lights will go on and off, don't pay attention to them.

5. After your 4WS light goes OFF, turn the steering wheel to CENTRE (turn it left) position within 4 seconds and hold it still.

6. When your 4WS light turns ON, turn your steering wheel CLOCKWISE again to 45-60 degrees and hold still (again within 4 seconds).

7. When the 4WS light goes OFF, turn the wheel to the centre position again within 4 seconds and hold it still.

8. If your 4WS light blinks TWICE then you succeeded.

If it stays on after this that means you failed, so simply turn the ignition off and go back to step one and try again. The tricky part with this procedure is that you should do all the steering inputs within 4 seconds so keep it in mind.

If you succeeded, turn your ignition off, remove the short on the service connector, start your engine and check if it's working. This may look complicated but it is very easy, it only takes a few minutes.